Savin 2513f Instrukcje Operacyjne Pobierz pdf (Strona 16)

Windows 95/98/Me Configuration

Configuring Protocols

Configuring TCP/IP and IPP for Printing

These instructions are for configuring the Network Interface Board and Win-

dows 95/98/Me to use the TCP/IP protocol and IPP.

Configuring the machine

Configure the machine to use the TCP/IP protocol.

• Make sure that the TCP/IP protocol is set to active. (The default is active.)

• Assign an IP address and make other settings required for using the TCP/IP

protocol.

Reference

For more information about how to make the above settings, see the System

Settings.

If DHCP is used to assign IP addresses, see P.90 “When Using DHCP”.

Note

❒ After setting the IP address, use the ping command to make sure that it has

been set correctly.

Click [Start], point to [Programs], and then click [MS-DOS Prompt].

Type the following: (Example IP address is 192.168.15.16)

C:\> ping 192.168.15.16

If the address has been configured correctly, the following message ap-

pears.

Reply from 192.168.15.16 : bytes=32 time<10ms TTL=32

If the address has been configured incorrectly, the following message ap-

pears.

Request timed out.

Configuring a Windows 95/98/Me computer

These steps are for configuring a Windows 95/98/Me computer to use the TCP/

IP protocol.

Open [Control Panel] and double-click the [Network] icon. Make sure that

“TCP/IP” is listed in the [The following network components are installed:] box on

the [Configuration] tab.

Note

❒ If the TCP/IP protocol is not installed, click [Add] on the [Configuration] tab

to install it. For more information about installing the TCP/IP protocol, see

Windows 95/98/Me Help.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 111 112

Brak uwag

Savin 2513f Instrukcje Operacyjne Strona 16